regyp pty ltd

Home/Tag: regyp pty ltd

REGYP NEWS ROOM – Goes Live

June 4th, 2010|

Subscribe to the Regyp News Room to receive up-to-date information on: - Construction and demolition waste services and specials; - Sustainable building practices; - Waste industry information including levy movements; - Gypsum product updates and specials; - Information on gypsum and the benefits of gypsum application; - Agricultural news. To subscribe follow the "Log In"

Plasterboard waste – Contamination

May 26th, 2010|

Waste Loads • All waste loads are inspected at REGYP disposal points; • Up to 2% contamination allowed (screening equip limit); • PENALTIES are imposed for contaminated loads; • A “Customer Code” is required to tip at the REGYP disposal points; • A payment method must be arranged before tipping or pickup. Acceptable Waste We

Gypsum spreading trials

February 12th, 2010|

ReGyp undertook spreader trials using the Super Ag 10mm screened gypsum product near Cowra NSW. The results off the spreader are substantial, with the Regyp gypsum spreading up to 19m (average 17-19), with various NSW mined gypsum products only achieving 11-13m off the same spreader. This increased spreading distance would equate to approximately $10 per

Effect of gypsum on topsoils

October 14th, 2009|

Gypsum improves the soil structure of hardsetting or crusting sodic clay topsoils, not only by reducing swelling, but also preventing clay dispersion. Sodic topsoil (0-10cm) usually has very poor structure – it is waterlogged when wet and too hard when dry. Sodic soil has too much sodium linking clay particles and not enough calcium. Sodic

Improving soil structure with gypsum

October 14th, 2009|

Gypsum works on improving spoil structure in two ways. Both depend upon the gypsum being dissolved by rain or irrigation water and entering the soil solution. The first is called the electrolyte effect which is based on the fact that swelling and clay dispersion of sodic clay soils decrease as the salinity of water infiltrating

Regyp Canberra ACT

July 1st, 2009|

ReGyp has partnered with Corkhill Bros of Canberra, to offer plasterboard/gyprock waste and recycling services in the ACT. Corkhill Bros will also distribute Super AG Gypsum from their Canberra sites. You have visited the REGYP News Room, for more info please visit the full REGYP website www.regyp.com.au , or call 1300 4 REGYP (73497) or

Waste avoidance and resource recovery

April 20th, 2009|

The NSW Waste Avoidance and Resource Recovery Report (WARR) 2008, stated that by increasing the cost of disposal of each tonne of waste, the expanded levy provides an incentive to provide recycling and resource recovery solutions. The levy will also provide revenue which will be used to fund new or expanded environmental programs in NSW.

C&D waste composition

April 19th, 2009|

In 2004 NSW DECC also undertook studies to estimate the the quantities and composition of mixed C&D waste disposed at Sydney landfills. Plasterboard waste was estimated to be around 4 percent of the total C&D waste stream with an expected tonnage range of between 10,000 and 25,000 tonnes per annum. The DECC testing called anything

Avoid landfilling plasterboard waste

February 21st, 2009|

Gyprock & Plasterboard Waste is 100% Recyclable The ReGyp recycling solution assures that the gyprock and plasterboard waste is 100% recyclable. The recycled gypsum powder which makes up to 94% of the waste, can used in industrial and agricultural apllications. The paper with related contaminants which makes up 6% of the waste can be reused

Dealing with gypsum waste in the US

September 21st, 2008|

Article - RecyclingToday - DEALING WITH GYPSUM - 8/6/2001 There is a lot of plasterboard produced in the US. In total, about 15 million tons of new plasterboard is produced each year (2000). California alone uses more than 10% of the nation’s total, or about 1.8 million tons per year, according to the state Waste